RFID Access Controller Locky-BP


Model RFID Access Controller Locky-BP

Short Description

The Locky-BP is a stand-alone RFID access controller. It works with 125kHz, EM4102 compatible, tags.

The controller utilizes main parts of access control system – reading antenna, microprocessor and output relay.

The access control decision is based on the status of approached tag. If the tag is valid (it is already programmed in the memory of the device) the relay is activated and it can switch an electric lock. Relay activation can be set up from 5 to 240 seconds.

RFID access controller Locky-BP has two hardware versions for different supply voltages. Standard Locky-BP works with 8 to 15VDC, while Locky-BP-40 has an extended supply voltage range from 8 to 40VDC.

There are two variants to set up the device – service tag and LockyMonitor2 software. The second variant is more powerful and recommended.


Supply voltage for Locky-BP-------------------8-15VDC
Supply voltage for Locky-BP-40----------------8-40VDC
Maximum consumption /with activated relay/---180mA @ 12VDC
Maximum switchable voltage/current------------60V / 0.3A
Dimmensions-----------------------------------Ø 38mm x 36mm
Operating temperature-------------------------from -10 to +40 С°
Reading distance-------------------------------at least 3cm
RFID tags--------------------------------------125kHz, EM4102 compatible
Non volatile memory----------------------------for up to 500 tags


* Memory for up to 500 valid tags;
* Compact design for easy installation;
* Asynchronous interface for PC control;
* Low power consumption;


* Service card programming – adding and group deleting of RFID tags
* PC programming – software LockyMonitor2
* ”Credit” mode – every tag has previous set up number of usage
* ”Statistic” mode – there is a counter of usage for every tag

Click here for Manual:

Please click below for complete product information.

  • Model: RFID Access Controller Locky-BP
  • Manufactured by: Teracom